Furuno BR-500 Operator's Manual page 37

2. Connect the signal cable to the WAGO terminal block on the Chassis. See the in-
terconnection diagram.
3. A gasket is fitted on the Chassis. Confirm that the gasket is correctly seated. If not
correctly seated, re-seat the gasket, referring to the illustration below for the in-
serting direction.
4. Fasten the Chassis to the Waterproof
Case with the screws supplied. Do
not use other types of screws; water-
tight integrity cannot be guaranteed.
5. Tighten the nut.
6. Fasten the unit to the mounting loca-
tion with the supplied self-tapping
screws (6×30, Code No. 000-162-
614-10).
Gasket
4. INSTALLATION
Inserting
direction
4-9