Fitting The Stability Bracket; Repositioning The Cooker Following Connection; Levelling - Falcon 900 Deluxe Induction G5 User's Manual & Installation Instructions

Fig.7-5
Fig.7-6
ArtNo.010-0004 Moving the cooker
Stability bracket
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Fig.7-7
Typical oor mounting
Typical oor mounting
Fig.7-8
Outer stability
bracket
3 mm min
Wall
Typical wall mounting
Typical wall mounting
Check the appliance is electrically safe when you have nished.
Cooker
Floor
Cooker
Floor
INSTALLATION
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, rst t a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig.7-5). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right-hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the oven
(Fig.7-6).
Carefully push the cooker backwards o the pack base.
Remove the pack base tray.
Position the cooker close to its nal position, leaving just
enough space to get behind it.
DO NOT use the door handles or control knobs to
n n
manoeuvre the cooker.

Fitting the Stability Bracket

Suitable stability devices are shown in Fig.7-7 and Fig.7-8.
If you are using a stability bracket (Fig.7-7 and Fig.7-8), then
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.7-6), you need to check behind the cooker to make sure
that the electricity cable is not caught.
As you progress, make sure that the electricity cable always
has su cient slack to allow the cooker to move.
When you replace the cooker, again check behind to make
sure that the electricity cable is not caught or trapped.

Levelling

You are recommended to use a spirit level on a shelf in one of
the ovens to check for level. Place the cooker in its intended
position taking care not to twist it within the gap between
the kitchen units as damage may occur to the cooker or the
units. The front feet and rear rollers can be adjusted to level
the cooker. To adjust the height of the rear of the cooker, use
a 13 mm spanner or socket wrench to turn the adjusting nuts
at the front bottom corners of the cooker.
To set the front turn the feet bases to raise or lower.
20