Falcon 900 Deluxe Induction G5 User's Manual & Installation Instructions page 21

The oven is not cooking evenly
Do not use a baking tray with dimensions larger than
those speci ed in the section on 'General Oven Tips' .
If you are cooking a large item, be prepared to turn it
round during cooking.
If two shelves are used, check that space has been left
for the heat to circulate. When a baking tray is put into
the oven, make sure that it is placed centrally on the
shelf.
Check that the door seal is not damaged and that the
door catch is adjusted so that the door is held rmly
against the seal.
A dish of water when placed on the shelf should be the
same depth all over. (For example, if it is deeper at the
back, then the back of the cooker should be raised up or
the front lowered.) If the cooker is not level, arrange for
your supplier to level it for you.
Oven temperature getting hotter as the cooker gets older
If turning the temperature down using the oven control
knob has not worked, or has only worked for a short
time, then you may need a new thermostat. This should
be tted by a service person.
The oven door is misaligned
The bottom hinge of the left-hand oven door can be
adjusted to alter the angle of the door (Fig.6-1). Loosen
the bottom hinge xing screws and use the notch and
a at bladed screwdriver to move the position of the
hinge to set the hinge position (Fig.6-2).
Retighten the hinge screws.
ArtNo.320-0006 Oven door hinge adjustment 1
E ect of hinge adjustment – exagerrated for clarity
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
17
Centreline of hinge pin
Fig.6-1
Fig.6-2