Pedestall Assembly And Ash Removal System Installation - Quadra-Fire 57ST-ACC Owner's Manual

R
B. Pedestal Assembly and Ash Removal
System (ARS) Installation
NOTE: The Ash Removal System, must be
installed first before installing the pedestal.
Included in Kit: Door assembly, door handle & magnet,
ash drawer, fastener package. A cover plate that is required
for a floor outside air installation on a pedestal model is also
included, if not needed, discard.
Tools Required: Phillips head screwdriver, 7/16 socket
wrench, /2 and 5/6 Allen wrench.
Begin installing the ARS System.
1. Remove bricks as shown in Figure 41.1 and remove
3
the ARS access cover with tool supplied in the compo-
nent pack.
2. Lay body of stove on its back on a protective pad or pallet.
. Remove the 2 nuts and 2 bolts holding the ash grate
channel in place and set the channel aside. Discard the 2
nuts. Install the gasket over the 8 protruding screws. Figure
41.2.
4. Install ash door assembly by sliding the rod at an angle
into the slot on the left side. Slide the door handle over
the rod and then finish pushing the rod through the slot.
Slide the ash door over the 8 screws protruding from the
bottom of the stove. Secure with nuts and washers pro-
vided. Figure 41.2.
5. Re-install handle using a /2 Allen wrench to tighten the
set screw in the door handle. The set screw needs to be
snug. Figure 41.3.
6. Install magnet using a Phillips head screwdriver. This
magnet will hold the door handle in an open position
which in turn holds the ash door open so ashes can be
brushed into the ash drawer. Figure 41.2.
WARNING!
Do NOT operate before fully assembling components.
Burning your stove without a pedestal or leg kit attached:
• Will void your warranty.
• May result in property damage or personal injury.
February 5, 2010
5700 Step Top Wood Stove Series ACC
installation and then re-install
Figure 41.1
D oor H andle
M agnet
S lide rod at an
angle into slot
Figure 41.2
S et S crew
(align w ith flat
side of rod)
D oor handle m ust be
in open position to
tighten set screw
Figure 41.3
7038-159C
ARS Cover
Remove 3 bricks for
G asket
Lay stove flat on
protective padding or
pallet
A sh D oor
A ssem bly
A sh D oor R od show n
in installed position
Page 41