LX-300+/1170
4.2 Disassembly and Assembly
This section explains the disassembly and assembly of Product Name. Unless otherwise
specified, assembly can be done in the reverse order of the disassembly procedure.
Anything that service person should pay attention to is described under "Check Point". Any
adjustment required after assembly is described under "Adjustment".
When you have to remove parts that are not described in this chapter, refer to the exploded
diagram on Appendix of this manual.
n
Read 4.1.1 "Precautions" before start disassembling the printer.
C A U T I O N
n
Remove ink ribbon and paper before disassembling the printer.
Disassembly and Assembly
The figure below is the disassembly flowchart for main component.
4.2.2 "Upper Housing
4.2.3 "Printer Mechanism
4.2.5 "C294MAIN/MAIN-
B Board Assembly
Flowchart 4-1. Disassembly Flowchart (Main Component)
Disassembly and Assembly
START
4.2.1 "Printhead
Removal"
Removal"
4.2.4 "Board Assembly
Removal"
and Panel Removal"
4.2.6 "C294 Power Supply
Board Assembly
Revision C
73