Led; Buzzer - Epson LX-300+ Service Manual

LX-300+/1170
o
Operation in default setting mode
The following switches are used in default setting mode;
Table 1-17. Operation at Power On
Switch Function
Tear Off Changes the setting.
LF/FF Selects the Menu.
The others Not available.

1.4.1.2 LED

o
Indication in normal mode
Table 1-18. Indication in normal mode
LED
*1
Pause
Printer Status
Pause On
Paper out error On
Release lever error On
Paper eject warning On
Micro Adjust Blink
Tear off ---
Font selection ---
Fatal error Blink
*1 Pause (Orange)
-It is on when the printer is paused, and it is off when the printer is not paused.
-It blinks when Micro Adjust is enabled.
*2 Paper Out (Red)
-It is on when the printer is in the Paper out status, and it is off when the printer is out
of this status.
PRODUCT DESCRIPTION
Paper
Font
*2
Out
--- ---
On ---
--- ---
Blink ---
--- ---
--- *3
--- *3
Blink Blink
*3 Font (Green)
-The status of Font selection is displayed by 2 Font LEDs when continuous paper is out
of the Tear-off position.
-Both LEDs blink when continuous paper is in the Tear-off position.
n
¨
: Draft
n
«
: Draft Condensed
n: Roman
¨
¨¨
: Roman Condensed
¨«
: Sans serif
n: Sans serif Condensed
«
««
: Tear Off
: LED On, n: LED Off,
¨
(

1.4.1.3 Buzzer

o
Paper out error:
o
Release lever operation:
o
Illegal panel operation:
*The description (.) and (-) in the above shows how the beeper sounds.
(.): Beeper sounds approx. 100ms and interval is approx. 100ms.
(-): Beeper sounds approx. 500ms and interval is approx. 100ms.
Operation
Revision C
«
: LED Blinks)
Beeper sounds (...)*
Beeper sounds(-----)*
Beeper sounds (.)*
27