Remote Starter Features; Idle Mode; Valet Mode; Ignition Valet - Autostart PD-2.7 User Manual

•
Turn the ignition key to the
position while the engine is running. This would cause the starter motor to re-engage.)
•
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.

Remote Starter Features

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
To leave the vehicle in Idle Mode
1. With the engine running, press the
START/ STOP
2. Remove the key and exit the vehicle. The engine will go on running.
3. Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode; at the last step, the
buttons:
1. Ensure that the doors are all closed and that the gearshift lever is in the
position.
2. With the engine already running, apply the parking brake and release the brake pedal.
• Make sure to release the brake pedal.
3. Within 20 sec. push
• The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press the
door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Valet Mode

When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.

Ignition Valet

This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
User Guide
IGNITION ON (RUN)
if your vehicle has an automatic
button on the remote control until the parking lights come on.
,
LOCK UNLOCK
button until the system is armed (the doors will be locked if remote
TRUNK
position. (Do not turn the key to the
or button (to unlock the doors) or the
LOCK UNLOCK
button is pressed instead of the other
TRUNK
or on the transmitter.
START/STOP
CRANK
transmission:
NEUTRAL
P. 5