1. Manuals
  2. Brands
  3. Autostart Manuals
  4. Remote Starter
  5. PD-2.7
  6. User manual

Autostart PD-2.7 User Manual

Automatic / manual transmission multi-channel remote starter
Hide thumbs
Table of Contents

Advertisement

Quick Links

A U T O M A T I C
M U L T I - C H A N N E L
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
DOC. 1.00
- 1W-AM-4B-SH-A-M -
/
M A N U A L
P D - 2 . 7
User Guide
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled
or put into valet mode before servicing.
- September 8, 2007 -
T R A N S M I S S I O N
R E M O T E
S T A R T E R
WARNING
- MO -
Assembled in Canada

Advertisement

Table of Contents
loading

Related Manuals for Autostart PD-2.7

Summary of Contents for Autostart PD-2.7

  • Page 1 A U T O M A T I C M A N U A L T R A N S M I S S I O N M U L T I - C H A N N E L R E M O T E S T A R T E R P D - 2 .

  • Page 2: Table Of Contents

    Table of Contents Introduction ............2 OEM alarm ............7 Using the Remote Control........3 Remote Door Locks ..........7 Vehicle Presets............3 Priority Door Access..........7 Heater & Heated Seat......... 3 Ignition-controlled Door Locks ......7 Windshield Wipers, Radio & Headlights ..... 3 Ignition Re-lock ...........

  • Page 3: Using The Remote Control

    Using the Remote Control Your Remote Car Starter is equipped with a 4-button multi-channel remote control. It can operate two independent vehicles equipped with a Remote Car Starter (see Multi-Car Operation section, later in this Guide, for second-car transmitter functions). The functions of the transmitter are as follows: N.B.: Pressing the buttons simultaneously will activate the...

  • Page 4: Remote-Starting Your Vehicle

    Remote-Starting Your Vehicle If your vehicle has an automatic transmission, simply press the button to remote start or START stop your vehicle. Skip the next steps on to “Remote-starting”. Warning: If you vehicle has an automatic transmission and the parking lights flash 15 times after pressing the button, the parking brake is connected to ground.

  • Page 5: Remote Starter Features

    • Turn the ignition key to the position. (Do not turn the key to the IGNITION ON (RUN) CRANK position while the engine is running. This would cause the starter motor to re-engage.) • Press the brake pedal to disengage the remote starter unit. You are now ready to drive off.

  • Page 6: Remote Valet Mode

    To put the system i n t o Valet Mode: • Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively into the positions. IGNITION ON / RUN • The parking lights will flash three times to indicate that the vehicle is now in Valet Mode. The L.E.D.

  • Page 7: Advanced Features: Installation-Programmable Options

    To enter Cold Weather Mode: • Press and hold the button for 3 seconds START/ STOP ... until the parking lights flash three times. To exit Cold Weather Mode, do any one of the following actions: • Open the hood. •...

  • Page 8: Ignition Re-Lock

    Ignition Re-lock On Remote Car Starters of this series, when Ignition-controlled Door Locks are enabled and the ignition key is in the position, should any door be unlocked and opened, all doors IGNITION ON (RUN) will be relocked next time the brake pedal is pressed. Secure Lock (Disabled by default.) Before it can remote-start your vehicle, the Remote Car Starter must first disarm the factory security system.

  • Page 9: Home Valet Tm " Mode

    The parking lights will flash twice and the L.E.D. will come indicating that the OUT, vehicle is now out of valet mode. Note: Once Valet Mode is activated, the remote starter and alarm functions will be disabled. “Home Valet ” Mode If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control.

  • Page 10: Engine Run Time

    Engine Run Time If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3, 15, or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).

  • Page 11: Troubleshooting Poor Transmitting Range

    Troubleshooting Poor Transmitting Range Many factors may affect the operating range of the transmitter. Some of these are: • The condition of the battery in the transmitter. • The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…) •...

Table of Contents