Driving Off; Remote Starter Features; Idle Mode; Valet Modes - Autostart CS-495iTW-FM User Manual

Driving Off

With the vehicle running under remote control, press the
Enter the vehicle and do the following:
•
Turn the ignition key to the
position while the engine is running. This would cause the starter motor to re-engage.)
•
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.

Remote Starter Features

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission:
1. With the engine running, press the
button on the remote control until the parking lights come on.
2. Remove the key and exit the vehicle. The engine will go on running.
3. Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode; at the last step, the
buttons:
4. Ensure that all the Doors are closed and that the Shifter is in the Neutral position.
5. With the Engine already running, apply the Parking Brake and release the Brake Pedal.
Make sure to release the brake pedal.
6. Within 20 sec. push
The parking lights will flash 3 times quickly and remain lit.
7. Remove the key: the Engine will go on running.
8. Exit the vehicle and close the Door.
9. Press the
lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Valet Modes

Ignition Valet

This feature will allow you to remotely put your system into valet mode by using the ignition key
instead of the valet button as above. Ignition valet can be used without a valet button installed.
To put the system i n t o valet mode:
• Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively
into the
IGNITION ON / RUN
User Guide
IGNITION ON (RUN)
, or on the Transmitter.
button until the system is armed (the doors will be locked if remote door
and positions.
OFF
button to disarm and unlock the doors.
position. (Do not turn the key to the
or button (to unlock the doors) or the
button is pressed instead of the other
CRANK
P. 7