Table of Contents
Advertisement
quickly and remain lit.
4.
Remove the key: the engine will continue running.
5.
Exit the vehicle and close all doors, hood and trunk.
6.
Press for approx. 1 second either:
a.
LOCK
b.
UNLOCK
c.
START/STOP
Remote starting
Press the
button for approximately 1 second. The parking lights will come
START
you that the Remote Car Starter has received your signal. Approximately 5 seconds later, the
engine will start. The parking lights will remain
engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds
and try to start the engine again. If your vehicle is equipped with an automatic transmission,
there will be 3 start attempts before the system gives up.
Driving Off
With the vehicle running under remote control, press the
the doors (if installed). Enter the vehicle and do the following:
•
Turn the ignition key to the
•
Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Caution: Do not turn the key to the
cause the starter motor to re-engage, unless your vehicle is equipped with the Starter Kill /
Anti-Grind Feature (Optional).
Remote starter features
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in
the Ignition Switch) while the engine is running.
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission:
1.
With the engine running, press the
the
START
2.
Remove the key and exit the vehicle. The engine will go on running.
3.
Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
If your vehicle has a manual transmission, Idle Mode can be activated through the same
routine as that used for Ready Mode; at the last step, the
the other buttons:
User Guide
to lock the doors and shut down the engine;
to unlock the doors and shut down the engine;
to shut down the engine without affecting the doors.
IGNITION ON (RUN)
button on the remote control until the parking lights come on.
during the pre-programmed run time of the
ON
UNLOCK
position.
position with the engine running. This will
CRANK
or
LOCK
UNLOCK
TRUNK
button to
DISARM
button (to unlock the doors) or
button is pressed instead of
to inform
ON
and
UNLOCK
P. 5
Hide quick links:
Advertisement
Table of Contents
