Hex Dump - OKIDATA OL400e Series Service Manual

Hex Dump

General Information
Data received by the printer is converted to hexadecimal codes and printed
when the printer is in HEX DUMP mode.
If the amount of data received is more than one page, printing will
automatically activate.
If the amount of data received is less than one page, you may have to manually
activate printing.
To print the page, you can do one of the following procedures.
- Press ON-LINE to place the printer OFF-LINE.
- Press FORM FEED / Tray Select.
- Set AUTO EJECT to ON in the menu.
Procedure
To enter hex dump mode, perform the following procedure.
- Close the stacker cover.
- Install the paper cassette tray.
- Clear all error messages displayed on the operator panel.
- Power OFF the unit.
- Press and hold MENU 1 / Menu 2 while powering ON the unit.
The operator panel displays the following for approximately two seconds.
- Release MENU 1 / Menu 2 once the operator panel displays the following message.
- Press MENU 1 / Menu 2.
The operator panel displays the following message.
- Press MENU 1 / Menu 2.
The operator panel displays the following message.
- Press ENTER / Copies
The operator panel displays the following message for approximately 15 seconds.
Service Manual for OL400e/OL410e/OL410e-PS
or
88888888
88888888
USER MNT
MENU
RESET
HEX DUMP
WARM UP
Chapter 3 Maintenance & Disassembly
Page: 139