Engine Maintenance Mode; Led Head Drive Time; Print Start Position; Drum Count Total Display - OKIDATA OL400e Series Service Manual

3.3.03 Engine Maintenance Mode

NOTE: The end user should NOT access the engine maintenance mode.
General Information
Engine maintenance mode allows the service technician to access the features listed below.

- LED Head Drive Time...............

- Print Start Position................... ( )

- Drum Count Total Display.........

- Drum Count Display................. ( )
- Engine Reset.......................... ( )
- Factory Adjustment for Second Tray / Multi-Feed
Do not change the setting for this feature!
Procedure
To enter the engine maintenance mode, perform the following procedure.
NOTE: Press ENTER / Menu Reset to execute any of the functions being displayed.
To exit from any of the functions being displayed, press ON-LINE.
- Close the stacker cover.
- Install the paper cassette tray.
- Clear all error messages displayed on the operator panel.
- Power OFF the unit.
- Press and hold ENTER / Copies and FORM FEED / Tray Select while
powering ON the unit.
- Continue to hold ENTER / COPIES and FORM FEED / Tray Select through
all panel displays.
- The operator panel displays the following message for approximately two seconds.
- The operator panel will briefly display the following message.
- Continue to hold ENTER / COPIES and FORM FEED / Tray Select until the operator
panel displays the following message.
- Press MENU 1 / Menu 2.
The operator panel displays the following message.
- Press MENU 1 / Menu 2.
The operator panel displays the following message.
Service Manual for OL400e/OL410e/OL410e-PS
88888888
88888888
INITIAL-
IZING
ENG MNT
LED HEAD
NO.16 *
PRINT POS
Chapter 3 Maintenance & Disassembly
( )
( )
Page: 151