Scanner Name - Honeywell Xenon 1900 User Manual

To put the scanner in multiple scanner mode, scan the bar code below. Once
you scan this bar code, the scanner is unlinked from the base and must be
placed into the base to re-link.
Multiple Scanner Operation

Scanner Name

You may assign a name to each scanner you are using. When you have multi-
ple scanners linked to one base, you may want to name each scanner so you
will be able to control the scanner receiving imaging commands sent from the
base.
The default name for a Xenon is "Xenon." If you have more than one scanner
linked to a base, and they all have the default names, the first scanner linked to
the base receives commands. You can change the name of a scanner using a
serial command (refer to Scanner Name, page 11-15) or using a bar code com-
mand. To change the name serially, unlink all except one of the scanners from
the base. Send ":Xenon:BT_NAM name .", where name is the new scanner
name. If you wish to change the names of additional scanners, re-link them one
at a time and repeat the ":Xenon:BT_NAM name ." command for each scanner.
3 - 20