Intercharacter Delay; User Specified Intercharacter Delay - Honeywell Xenon 1900 User Manual

Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may
be placed between the transmission of each character of scanned data.
Scan the Intercharacter Delay bar code below, then scan the number of
5ms delays, and the Save bar code using the
the back cover of this manual.
To remove this delay, scan the Intercharacter Delay bar code, then set the
number of delays to 0. Scan the Save bar code using the
Chart inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments)
may be placed after the transmission of a particular character of scanned
data. Scan the Delay Length bar code below, then scan the number of
5ms delays, and the Save bar code using the
the back cover of this manual.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex
value for the ASCII character that will trigger the delay
Chart (Code Page 1252)
Delay Length
To remove this delay, scan the Delay Length bar code, and set the number
of delays to 0. Scan the Save bar code using the
inside the back cover of this manual.
Prefix Scanned Data
1 2 3
Intercharacter Delay
Intercharacter Delay
on page A-4.
Programming Chart
Suffix
4 5
Programming Chart
ASCII Conversion
Character to Trigger Delay
Programming Chart
inside
Programming
inside
5 - 5