Scanner To Bioptic Communication; Scanner-Bioptic Packet Mode - Honeywell Xenon 1900 User Manual

the scanner waits for ACK/NAK again. Turn on the ACK/NAK protocol by
scanning the ACK/NAK On bar code below. To turn off the protocol, scan
ACK/NAK Off. Default = ACK/NAK Off .
ACK/NAK On

Scanner to Bioptic Communication

The following settings are used to set up communication between Honeywell
scanners and bioptic scanners.
Note: The scanner's baud rate must be set to 38400 and the RS232 timeout
must be set to 3000 in order to communicate with a bioptic scanner. See
RS232 Baud Rate
further information.

Scanner-Bioptic Packet Mode

Packet Mode On must be scanned to set the scanner's format so it is com-
patible with a bioptic scanner. Default = Packet Mode Off.
* Packet Mode Off
2 - 26
on page 2-22, and
* ACK/NAK Off
RS232 Timeout on page 2-25 for
Packet Mode On