Resetting The Custom Defaults - Honeywell Xenon 1900 User Manual

When you have entered all the commands you want to save for your custom
defaults, scan the Save Custom Defaults bar code.
Set Custom Defaults
Note: If using a cordless system, scanning the Save Defaults bar code also
causes both the scanner and the base to perform a reset and become
unlinked. The scanner must be placed in its base to re-establish the link
before any setup codes are entered. See
Operation
You may have a series of custom settings and want to correct a single setting.
To do so, just scan the new setting to overwrite the old one. For example, if you
had previously saved the setting for Beeper Volume at Low to your custom
defaults, and decide you want ithe beeper volume set to High, just scan the Set
Custom Defaults bar code, then scan the Beeper Volume High menu code,
and then Save Custom Defaults. The rest of the custom defaults will remain,
but the beeper volume settiing will be updated.

Resetting the Custom Defaults

If you want the custom default settings restored to your scanner, scan the Cus-
tom Product Default Settings bar code below. This resets the scanner to the
custom defaults. If there are no custom defaults, it will reset the scanner to the
factory defaults. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
Note: If using a cordless system, scanning this bar code also causes both the
scanner and the base to perform a reset and become unlinked. The
scanner must be placed in its base to re-establish the link. See
System Operation
1 - 10
beginning on page 3-1 for additional information.
Custom Product Default Settings:
Current Application Group
beginning on page 3-1 for additional information.
Save Custom Defaults
Cordless System
Cordless