Resetting the Factory Defaults
If you aren't sure what programming options are in your scanner, or you've
changed some options and want the factory default settings restored, first scan
the Restore Factory Defaults bar code, then scan Save Defaults. This resets
the scanner to the factory defaults.
Restore Factory Defaults
Note: If using a cordless system, scanning the Save Defaults bar code also
causes both the scanner and the base to perform a reset and become
unlinked. The scanner must be placed in its base to re-establish the link
before any setup codes are entered. See
Operation
The
Menu Commands,
for each of the commands (indicated by an asterisk (*) on the programming
pages).
Setting Custom Defaults
You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults bar code below before each
menu command or sequence you want saved. If your command requires scan-
ning numeric codes from the back cover, then a Save code, that entire
sequence will be saved to your custom defaults. Scan the Set Custom
Defaults code again before the next command you want saved to your custom
defaults.
beginning on page 3-1 for additional information.
beginning on page 11-5 list the factory default settings
Save Defaults
Cordless System
1 - 9