Replacing An Interface Cable; Replacing Cables And Batteries In Cordless Systems; Replacing An Interface Cable In A Base - Honeywell Xenon 1900 User Manual

Area-imaging scanner
Hide thumbs Also See for Xenon 1900:
Table of Contents

Advertisement

• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the
original interface cable.

Replacing an Interface Cable

1. Turn the power to the host system
OFF.
2. Disconnect the scanner's cable
from the terminal or computer.
3. Locate the small hole on the back
of the scanner's handle. This is
the cable release.
4. Straighten one end of a paper
clip.
5. Insert the end of the paper clip
into the small hole and press in.
This depresses the retention tab,
releasing the connector. Pull the
connector out while maintaining
pressure on the paper clip, then
remove the paper clip.
6. Replace with the new cable.
Insert the connector into the opening and press firmly. The connector is
keyed to go in only one way, and will click into place.
Replacing Cables and Batteries in Cordless
Systems

Replacing an Interface Cable in a Base

1. Turn the power to the host system
OFF.
2. Disconnect the base's cable from the
terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while
maintaining pressure on the
connector release clip.
5. Replace with the new cable.
Insert the connector into the opening
13 - 2
Cable
Release

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xenon 1902

Table of Contents