Multiple Scanner Operation; Scanner Name - Honeywell Voyager 1602g User Manual

Multiple Scanner Operation

Note: Multiple Scanner Operation Mode allows you to link up to 6 scanners to one Access
Point. You cannot join an 7th scanner until you unlink one of the 6 scanners or take a
scanner out of range.
To put the scanner in multiple scanner mode, scan the barcode below. Once you
scan this barcode, the scanner is unlinked from the current host and must be
paired with a host to relink.

Scanner Name

You may assign a name to each scanner you are using for identification purposes.
For example, you may want to have a unique identifier for a scanner that is receiv-
ing specific commands sent from the host.
The default name is in the format "ScannerName_Model_SN_XXXXXXXXXX" If you
have more than one scanner linked to a host and they all have the same name, the
first scanner linked to the host receives commands. When renaming a series of
scanners with identical names, unlink all except one of the scanners from the host.
Perform the rename operation using either the barcodes on
the serial command :ScannerName:BT_NAMNewName. where ScannerName is the
current name of the scanner, and NewName is the new name for the scanner. If you
wish to change the names of additional scanners, link them one at a time and
repeat the :ScannerName:BT_NAMNewName. command for each scanner.
Voyager 1602g User Guide
* Full Power
Medium Low Power
Multiple Scanner Operation
Medium Power
Low Power
page 52, or by sending
51