Open Link Mode - Single Scanner; Unlinking The Scanner; Override Locked Scanner; Out-Of-Range Alarm - Honeywell Xenon 1900 User Manual

Open Link Mode - Single Scanner

When newly shipped or defaulted to factory settings, the base and scanner
are not linked. By placing a scanner into the base, they establish a link.
Placing a different scanner into the base establishes a new link and the old
scanner is unlinked. Each time a scanner is placed into the base, it
becomes the linked scanner; the old scanner is unlinked.

Unlinking the Scanner

If the base has a scanner linked to it, that scanner must be unlinked before a
new scanner can be linked. Once the previous scanner is unlinked, it will no
longer communicate with the base. To unlink a scanner from the base, scan the
Unlink Scanner bar code below.

Override Locked Scanner

If you need to replace a broken or lost scanner that is linked to a base, scan
the Override Locked Scanner bar code below with a new scanner and
place that scanner in the base. The locked link will be overridden; the bro-
ken or lost scanner's link with the base will be removed, and the new scan-
ner will be linked.

Out-of-Range Alarm

If your scanner is out range of the base, an alarm sounds from both your base
and scanner. The alarm stops when the scanner is moved closer to the base,
when the base connects to another scanner, or when the alarm duration
expires. To activate the alarm options for the scanner or the base and to set the
* Open Link Mode
(Single Scanner)
Unlink Scanner
Override Locked Scanner
(Single Scanner)
3 - 11