Monitoring One Channel - GRE PSR-216 Owner's Manual

1. Press BAND. The last selected band number (b followed
by a number, such as b2) and the associated frequency
search range appear on the display.
2. To select a different band, within 2 seconds, enter the de-
sired band number or repeatedly press BAND until the
desired band number appears on the display. After about
2 seconds, SRCH, > appears, and the scanner begins
searching rapidly upward in that band (from lowest to high-
est frequency) for an active frequency.
Note: To select a different band after the scanner begins
searching the current band, simply repeat this step.
3. When the scanner finds an active frequency, it stops
searching and displays that frequency's number. To con-
tinue the search, press and hold > or < about a second.
Direct Search
During a direct search, the scanner searches upward or
downward, starting from a frequency you specify. Follow
these steps to use direct search.
1. Press MAN or PROG, then enter the frequency you want
to use as a starting point for the search.
Note: To start from a frequency already stored in one of
your scanner's channels, press MAN or PROG, enter the
desired channel number, then press MAN or PROG again.
2. Press and hold > or < for about a second to search up-
ward or downward. –d–, SRCH and > or < appear on
the display.
3. When the scanner finds an active frequency, it stops
searching and displays that frequency's number. To con-
tinue the search, press and hold > or < about a second.

MONITORING ONE CHANNEL

You can continuously monitor a specific channel without
scanning. This is useful if you hear an emergency broadcast
on a channel and do not want to miss any details — even
though there might be periods of silence — or if you simply
want to monitor that channel.
Follow these steps to manually select a channel.
1. Press MAN.
2. Enter the channel number.
3. Press MAN again.
Page 15
15
2004/04/08, 16:50