Understanding Bank/Bands/Monitor Memory - GRE PSR-216 Owner's Manual

L/O – appears when you listen to a channel that is locked
out of the scan mode.
Display Message
Error – appears when you make an entry error.
–dUPL– – (duplicate) appears when you try to store a fre-
quency that is already stored in another channel.
–L– – appears during a limit search.
Lo – appears when you program a lower limit frequency
range.
Hi – appears when you program a higher limit frequency
range.
–d– – appears during a direct search.
bX (X: 1 to 0, search band number) – appears during a
band search.
ALL Ch0000 – appears when you clear all stored channels.
Ch–FULL – appears when you try to enter a frequency into a
channel during a search when all channels are full.
L–o Ch0000 – appears when you clear all locked-out chan-
nels.
Lo ALL–CL – appears when you remove all lockouts from
channels.
P .–SA – appears when the scanner turns on the power save
feature.
rE. St – appear when press CLEAR to stop limit search or
band search. In this condition press > to start up search
from the bottom band edge and press < to start down search
from the top band edge.
UNDERSTANDING BANK/BANDS/MONITOR
MEMORY
Channel Storage banks
To make it easier to identify and select the channels you want
to listen to, channels are divided into 10 banks of 20 chan-
nels each. Use each channel-storage bank to group frequen-
cies, such as those used by the fire department, ambulance
services, or aircraft.
10
Page 10 2004/04/08, 16:50