Operation; Turning On The Scanner/Setting Volume And Squelch; Programming Frequencies - GRE PSR-216 Owner's Manual

OPERATION

TURNING ON THE SCANNER/SETTING
VOLUME AND SQUELCH
1. Turn the SQUELCH knob fully counterclockwise.
2. Turn the VOLUME knob clockwise until it clicks and you
hear a hissing sound.
3. Turn the SQUELCH knob clockwise until the hissing sound
stops.
Notes:
• If the scanner picks up unwanted, partial, or very weak
transmissions, turn SQUELCH clockwise to decrease the
scanner's sensitivity to these signals. If you want to listen
to a weak or distant station, turn SQUELCH counterclock-
wise.
• If SQUELCH is adjusted so you always hear a hissing
sound, the scanner does not scan properly.
• If you have not stored frequencies into any channels, the
scanner does not scan.

PROGRAMMING FREQUENCIES

Your scanner is capable of storing up to 200 frequencies.
You can program the frequencies randomly or match chan-
nel numbers with car numbers, TV and radio call numbers,
etc.
To program frequencies:
1. Press PROG. PROG appears.
2. To select the channel where you want to store the fre-
quency, use the number keys to enter the channel num-
ber, then press PROG.
3. Using the number keys and •/DELAY, enter the frequency
you want to store into that channel.
4. Press ENT to store the frequency.
Notes:
• If you entered an invalid frequency in Step 3, the scanner
beeps and displays the channel number and Error. Sim-
ply repeat Steps 3 and 4.
12
Page 12 2004/04/08, 16:50