Table of Contents
Advertisement
Setting coarse elevation
The antenna pointing procedure begins with the steps described
in this section and continues through the end of this chapter.
Follow the instructions in the order they are presented.
Set the initial (coarse) antenna elevation to the initial elevation
value given by the installation software, as follows:
1. Loosen the two fine elevation adjustment nuts indicated in
Figure 49 so the antenna reflector can move forward and
backward.
2. Loosen the two elevation lockdown
Figure 49, a little at a time, until you can rotate the antenna
reflector forward and backward to adjust the elevation.
Note: Do not tighten the elevation lockdown bolts yet
because you will be adjusting elevation further, as explained
in Fine elevation adjustment on page 62.
3. Set the elevation to the value given by the installation
software.
Elevation scale
Figure 49: Setting coarse elevation
indicated in
bolts
Elevation lockdown bolts (2)
Chapter 7 • Pointing the antenna
1037312-0001 Revision A
Fine elevation
adjustment nuts
Arrow
indicates
movement
during
elevation
adjustment.
61
Advertisement
Table of Contents
