Installing The Radio Assembly; Attaching The Feed Horn; Attaching The Feed Horn And Radio Assembly - Hughes AN6-098P Installation Manual

.98 m ku-band upgradeable antenna

Hide thumbs Also See for AN6-098P:

Table of Contents

Installing the radio

assembly

Chapter 5 • Installing a cradle-type radio assembly

1037312-0001 Revision A

This section explains how to install the cradle-type radio

assembly. You must use the antenna kit indicated in Table 1 on

page 8 for the cradle-type radio assembly.

7. To attach the feed horn to the radio assembly, refer to Figures

34 and 35 and follow steps 1 through 3 below.

Screws and

washers

Feed horn

Figure 34: Attaching the feed horn and radio assembly

1. Remove the protective covering from the small end of the

feed horn.

CAUTION

• If you do not remove the protective covering from the

small end of the feed horn, the system may operate, but

with degraded performance.

• Do not remove the protective packing material from the

feed horn window until you finish installation of the

radio assembly.

O-ring

T0172013

Table of Contents