Table of Contents
Advertisement
Installing the radio
assembly
Attaching the upper
mounting bracket
Chapter 4 • Installing a J-type radio assembly
36
1037312-0001 Revision A
This section explains how to install the J-type radio assembly.
You must use the antenna kit indicated in Table 1 on page 8 for
the J-type radio assembly.
Attach the upper mounting bracket to the transmitter:
1. Place the upper mounting bracket onto the transmitter, in the
position shown in Figure 27.
Align the two bolt holes in the bracket with the holes in the
transmitter.
2. Secure the bracket to the transmitter with two
hex bolts, lock washers, and flat washers.
3. Tighten the bolts.
Note: The transmitter may look a little
different than the one shown here.
Figure 27: Attaching the upper mounting bracket
Mounting
Bolts
bracket
⁄
5
-18 × 1-inch
16
Transmitter
Advertisement
Table of Contents
