Table of Contents
Advertisement
Arrows above point to mounting screws. One screw,
indicated by the gray arrow, is not visible in this photo.
Chapter 3 • Assembling the antenna
26
1037312-0001 Revision A
Reflector attached to bracket
Figure 17: Mounting the reflector on the reflector bracket
3. Insert two ¼-20 × 1-
(without washers) through the upper holes on the reflector
bracket and into the reflector holes indicated in Figure 17
(upper arrows on the right photo).
4. Partially tighten the screws.
5. Insert two ¼-20 × 1-
(without washers) through the lower holes on the reflector
bracket and into the lower reflector holes.
6. Tighten each screw a little; then move on to the next screw.
7. Use a torque wrench to tighten the screws to 10 ft-lb force
maximum.
CAUTION
To avoid damaging the mounting holes in the back of the
reflector, do not overtighten the reflector bracket screws.
Use a torque wrench.
Mounting holes (arrows)
on back of reflector
⁄
3
-inch hex thread-cutting screws
8
⁄
1
-inch hex thread-cutting screws
16
Advertisement
Table of Contents
