Table of Contents
Advertisement
Chapter 4 • Installing a J-type radio assembly
40
1037312-0001 Revision A
4. Tighten the nuts.
Match round hole
in adapter to round
hole in tube.
T0172015
Figure 32: Attaching the radio assembly to the feed support tube
Attach the upper and lower mounting brackets to each other, as
shown in Figure 33:
1. Place the radio assembly (attached to the upper bracket in
previous steps) onto the lower bracket.
2. Align the four mounting holes on the upper and lower
mounting brackets.
3. Insert a ¼-20 × 0.75-inch carriage bolt through each of the
four mounting holes.
4. From below, place a ¼-inch flat washer, lock washer, and hex
nut on each bolt.
5/16-18 x 2.5-inch
carriage bolts
Lower mounting bracket
Mounting adapter
Feed support tube
Match oval slot in adapter
to oval slot in tube.
Advertisement
Table of Contents
