Table of Contents
Advertisement
Setting the radio
Chapter 5 • Installing a cradle-type radio assembly
48
1037312-0001 Revision A
Set polarization on the cradle-type radio as follows:
polarization
1. Before proceeding, make sure the antenna polarization is set
to 0°. See Setting polarization on page 63.
2. On the radio assembly, loosen the two screws at the top of the
two circular brackets at each end of the transmitter. (Each of
these brackets has a polarization scale.) See Figure 37.
Positive
polarization
scale
Figure 37: Rear circular bracket with polarization scale
3. Set the radio polarization to the calculated setting by rotating
the radio and using the polarization scales on the circular
brackets.
Plus ( + ) and ( – ) minus signs at the top of each scale
indicate positive or negative values. Make sure you read the
correct scale.
4. Tighten the two screws on the circular bracket.
This completes installation of the radio assembly.
Screw
Negative
polarization
scale
To set polarization, align marker
indicated by black arrow to the
desired value on the scale. The
setting in this photo is close to 0
°
.
Advertisement
Table of Contents
