Ir Code Confl Icts / Ir Extender Installation - Gefen EXT-DVIKVM-241SL User Manual

In the event of IR confl icts, please do the following:
1. Remove the battery cover from the back of the RMT 2-IR remote.
2. Locate the Dip Switches above the batteries
3. Switch the Dip Switches on the RMT 2-IR to any of the combinations pictured below.
4. Dip Switches 1 and 2 in the RMT 2-IR correspond with Dip Switches 1 and 2 on the
outside of the 2x1 DVI SL Switcher respectively. Flip the switches on the outside of the
2x1 DVI SL Switcher to match the same Remote Channel as the RMT 2-IR. The 2x1
DVI SL Switcher is now set to a new IR Code.
Remote Channel 1:
Remote Channel 3:
1 Locate the dip switches underneath the switcher, they will be hidden underneath a
blank silver sticker, and fl ip dip switch number 4 to the "ON" position.
2 Plug the IR extender into the Remote port on the front of the Switcher Unit
You should now be able to switch using the IR Extender.
IR CODE CONFLICTS
1 2
1 2
IR EXTENDER INSTALLATION
How to Connect the IR Extender
7
Remote Channel 2:
Remote Channel 4:
1 2
1 2