Loading Media Into The Printer - Toshiba B-852-TS22-QQ-R Owner's Manual

2. PRINTER SETUP
2.4.2 Installing the Supply
Holder Unit onto the
Supply Holder Frame
NOTE:
Make sure that the brass bushings of
the Supply Shaft are seated into the
notches so that the entire Supply
Holder Unit rotates smoothly.
CAUTION!
The reassembled Supply Holder
Unit and media roll may be quite
heavy, so be careful not to pinch
your fingers when installing the
Supply Holder Unit onto the
Supply Holder Frame.
2.4.3 Loading Media into the
Printer
WARNING!
The Top Cover can be opened
during the operation for control
purposes only. It should be
closed during normal operation.
1. Insert the assembled Supply Holder Unit into the rear notches of the
Supply Holder Frame as shown in the diagram below.
Supply Holder
Frame
2. Now feed the media from the bottom of the media roll into the media
slot at the rear of the printer as shown.
The following paragraphs outlines how to properly install the media into
the printer from the Supply Holder Unit that has been installed in the
previous steps.
1. Raise the Top Cover as shown in the diagram below.
Top Cover
E2- 7
ENGLISH VERSION EO1-33055
Rear Notch
2.4 Loading the Media
Brass Bushing