Toshiba B-852-TS22-QQ-R Owner's Manual page 21

2. PRINTER SETUP
2.4.3 Loading Media into the
Printer (Cont.)
WARNING!
1. The Print Head may become
hot. Do not touch the Print
Head.
2. Risk of injuries. Do not touch
moving parts. Disconnect the
mains before maintenance of
ribbon and media.
CAUTION!
Be careful not touch the Print
Head Element when raising the
Print Head Block. Failure to do
this may cause missing dots by
static electricity or other print
quality problems.
2. Release the Print Head Block by pressing down on the Head Block
Release Lever
3. Raise the Print Head Block to its fully open position as shown by the
arrow in the above diagram.
4. Release the locking levers on the two paper guides as shown in the
figure below.
5. Grasp the right hand Paper Guide and move it to the right to open the
Paper Guides wide enough to accept the media.
6. Feed the media between the two guides.
7. Feed the paper under the Upper Sensor Ass'y and pull the paper until
it extends past the Platen. (until it extends past the cutter outlet when
the optional cutter is attached.)
8. Grasp the right Paper Guide and move it to the left to close both Paper
Guides and automatically center the media.
9. Press the Paper Guide Locking Levers to lock the Paper Guides in
place.
Lock
Paper Guide
Paper Guide
Locking Lever
E2- 8
as shown below.
Print Head Block
Head Block
Release Lever
Free
Platen
ENGLISH VERSION EO1-33055
2.4 Loading the Media
Print Head Element
Paper Guide
Upper Sensor Ass'y