Motion / Event Input; Hdd Setup; Sensor Setup; Sensor - OpenEye OE2-E48016 User Manual

Motion / Event Input

Motion / Event Setup allows you to enable recording or relay response on Motion, Sensor Event, and Video Loss
Motion
Enable– ON/OFF [Enable Event Input]
Sensitivity – 1~5 [Define Motion sensitivity level 1=least sensitive.]
Area – Red=selected, White=clear. Click to select/clear boxes.[Create or clear the motion area on the camera.]

Sensor

Sensor – ON/OFF [Enable recording on sensor event.]
Sensor Detail – All / 1~16 / All Channel [Associate sensors with channels. Select the All check box to associate all sensors
used to activate recording for that channel. Select the All Channel check box to associate the selected sensors with all
channels.]
Video Loss
VideoLoss – ON/OFF [Enable event on video loss.]
Video Loss Detail – All / 1~16 / All Channel [Associate video loss "V" alert with specific viewed channels. Select the All
check box to prompt all channels with video loss to provide a "V" alert to the viewed channel; Select the All Channel check
box to associate the selected channels to report a "V" alert when video loss occurs.]

HDD Setup

Disk Overwrite – Enable / Disable [Select the check box to enable the DVR to write over old data when the hard drive is
full.]
Disk Full Warning – Enable/Disable [Enable Disk Full Warning for notification when the HDD becomes full and HDD
Overwrite is disabled.]
Remain Time – 0~60 [Define the amount of remaining recording time to trigger the Disk Full Warning.]
Used Space – 80~99 [Define the percentage HDD used that triggers the Disk Full Warning.]
Disk Full Alarm – 0~8 [Define the relay that will trigger when the HDD is full.]
Disk Full Buzzer – Enable/Disable [Enable a continuous buzzer to sound for Disk Full Warning.]
Disk Full Message– Enable/Disable [Enable a popup message to display for Disk Full Warning.]

Sensor Setup

Sensor
Sensor – NO/NC [Set sensors to Normally Open or Normally Closed.]
Alarm Out – OFF/ON [Set Relay switches to Off or On.]
Note This section located in the RECORD > EVENT SETUP section on the E-Series server.
58