Chapter 2
The following procedures instruct users to install a motherboard, add-on
cards, and disk drives into the ACP-2010MB. Refer to Appendix A, the
Exploded Diagram and the Parts List for more detailed information about
the parts of the ACP-2010MB.
Note:
2.1 Removing the Chassis Cover
To remove the cover, please proceed as below.
1.
Loosen six screws on the rear and both sides of the top cover.
2.
Pull the L-type chassis top cover backwards and then lift it up.
ACP-2010MB User Manual
System Setup
Use caution when installing or operating
the components with the chassis open. Be
sure to turn off the power, unplug the power
cord and ground yourself by touching the
metal chassis before you handle any com-
ponents inside the machine.
Figure 2.1: Removing the chassis top cover
8