Please also refer to Chapter 6 of "Full Disassembly Procedure to set it.
Up. The default setting of JP6 is 5V.
3.5 NTSC/PAL TV type Setting (J1)
The ARK-3380 series of embedded box computer provide a jumper of J1
located on internal MIO-253 module I/O board for selecting the NTSC or
PAL type of TV set. When you connect your TVset to the S-Video or
Composite Video output connector, you need to set up this J1 for selec-
tion for TV mode.
Table 3.3: Type 3.3: NTSC/PAL TV selection(J1)
Close pins
1-2
2-3
(*): means default setting of the jumper/function
Please also refer to Chapter 6 of "Full Disassembly Procedure to set it.
Up. The default setting of J1is PAL TV..
3.6 Installing the DDR SDRAM Memory Module
The ARK-3380 provides one 200-pin SODIMM (Small Outline Dual
Inline Memory Module) socket and supports 2.5V DDR SDRAM. You
can install from 64 MB to 1 GB of DDR SDRAM memory. The proce-
dure of installing a DDR SDRAM SODIMM into the ARK-3380 is
detailed below, please follow these steps carefully.
1. Remove the power cord.
2. Unscrew the four screws from the bottom cover of the ARK-3380.
3. Remove the bottom cover.
4. Plug a DDR SDRAM SODIMM with your OS or application program
into a DDR SDRAM SODIMM on board.
4. Screw back the bottom cover with four screws.
ARK-3380 User Manual
Function
PAL*
NTSC
22