Table of Contents
Advertisement
attentIon
Install the heat pump only indoors and operate
only with outside air as the heat source. The air
ducts must discharge into the open air. do not
restrict or block the air ducts.
dimensional drawing and installation plan for
respective model.
WarnIng!
switch on unit only if air ducts are
mounted on the unit.
take measures on the fan side to prevent
injuries from the rotating fan (above-
ground air duct discharge: below-ground
air-channel discharge: wire mesh grille
– accessories not included in scope of
delivery).
attentIon
The integration of the heat pump in ventila-
tion systems is not permissible. The use of the
cooled air for cooling purposes is not permitted.
attentIon
The ambient air in the location where the heat-
ing pump is installed and also the intake air which
is used as a source of heat must not contain any
kind of corrosive components!
components such as ammonia, sulphur, chlo-
rine, salt, sewer gas, flue gases etc. may cause
damage leading to complete failure or even a to-
tal write-off of the heating pump!
CautIon!
In the air outlet area the air temperature
is ca. 5 K below the ambient temperature.
under
certain
therefore, an ice layer can form in the
air outlet area. Install the heat pump so
that the air blower does not blow in the
direction of footpaths.
We reserve the right to make technical changes
climatic
conditions,
83050406cUK – Translation of the operating manual
Customer service
for technical assistance, please contact your qualified
technician or the manufacturer's local service partner.
overview "customer service".
Warranty / Guarantee
for warranty and guarantee conditions, please refer to
the purchase documents.
notICe.
please contact your dealer concerning warran-
ties and guarantees.
Disposal
When decommissioning the unit, always comply with
applicable laws, directives and standards for therecovery,
recycling and disposal of materials and components of
cooling units.
dismantling.
NIBE
AP-AW10
TM
5
Advertisement
Table of Contents
