Table of Contents
Advertisement
Insert the power line and the sensor wires into the
unit through the rubber sockets on the back of the
unit...
1 Rubber sockets
for positioning of the rubber sockets for
inserting the wires, see "dimensional drawing"
for the respective model.
The wires inside the unit are guided in a closed wire
duct to the switch cabinet...
1 Wire duct in unit
2 cable glands switch cabinet
3 connections for power
and control wires
4 connections for regulator board
Install electric connections according to the
terminal diagram that applies to your model...
Terminal diagram for respective model.
20
NIBE
AP-AW10
TM
We reserve the right to make technical changes
attentIon
Ensure clockwise rotary field of the load power
supply (compressor).
–
An incorrect rotary field of the compressor
during operation can cause serious, irreparable
damage to the compressor.
attentIon
make sure to equip the power supply of the heat
pump with a 3-pole automatic cut-out with at
least 3mm contact gap.
Note the level of the release current.
1
overview "Technical data / scope of delivery",
"Electric" section.
E
D
CautIon.
The sensor cable for heat quantity recording
may not be shortened!
C
notICe.
The control element of the heat and heat pump
regulator can be a connection with a computer
or network using an network cable designed for
such pruposes, thus allowing the heating and
B
heat pump regulator to be controlled remotely.
If such a connection is desired, install a screened
network cable (category 6, with RJ-45 plug)
Blattformat: A4 hoch
through the unit when installing the connections
Allgemein-
and run it through the front facade of the unit,
toleranz
DIN ISO 2768 -c
parallel to the already-present heating and heat
Erstellt
pump regulator control cable.
Gepr.
Norm.
Alpha-InnoTec GmbH
Industriestraße 3
D - 95359 Kasendorf
close electrical switch cabinet of unit.
-
9.2.2009
HS
www.alpha-innotec.de
Zust.
Änderungstext
Datum
Von
83050406cUK – Translation of the operating manual
2
3
1:2
Maßstab
Ober ächen
Werksto
-
---
Datum
Name
Benennung
Durch usssensor VFS5-100
9.2.2009
Stenglein
ArtikelNr.
603772
Ers. f.
4
Schutzvermerk nach DIN 34 beachten
Det. Maßstab
Gewicht
Blatt
1
von
1
Ers. d.
Advertisement
Table of Contents
