Nibe AP-AW10 Operating Manual page 23

notICe.
To ensure good seating of the motor on the
valve, make sure that the u-bolt with the reduc-
tion is not pushed past the lug, because then the
motor will not be held securely on the valve!
In order to be supported securely, the u-bolt must
bear with both ends against the lug.
bleed the heating circuit and hot water circuit...
Ap-AW10-6c-8c
1 bleed valve
We reserve the right to make technical changes
If no further steps follow, install the bottom front
panel.
proCeed as follows for the ap-aW10-12C:
If unit is closed, open bottom front panel...
loosen the quick-release screws for the lower front
panel (= control side), remove lower front panel and
set aside...
Rinse and fill unit via the filling and emptying valve...
83050406cUK – Translation of the operating manual
Ap-AW10-10c
1 bleed valve
1 permanent bleeder
notICe.
once the heat pump, the heating circuit and the
hot water circuit have been rinsed, the bleed
program of the heating and heat pump regulator
must be started, after the control element has
been mounted.
"Transport with a hand truck"
NIBE AP-AW10 23
TM