Team Losi Triple-XT Sport Owner's Manual page 25

Figure 49
!
Step 6. Using needle-nose pliers, or small vise grips, grasp
the front shock shaft (118) between the grooves and thread a
shock end (120) onto the shaft (118). Thread the shock end (120)
all the way onto the shaft (118) until the threads stop.
!
Step 7. Repeat Step 6 for the second front shaft (118) and two
rear shock shafts (119).
!
Step 8. Carefully snap a 1/4" shock mount ball (122) into
each of the shock ends (120) attached to the shorter, front shock
shafts (118) only.
IMPORTANT NOTE: Do not insert 1/4" balls into
the rear shock ends (attached to the longer shafts). These balls
are already attached to the rear suspension arms.
Figure 50
!
Step 9. Snap a 1/8" E-clip (41) into the groove closest to the
cartridge on both rear shock shafts (119).
!
Step 10. Before installing the E-clip (41) to the front shock
shafts (118) — the shorter of the two lengths — slide a .050" shock
spacer (121) over the shaft (118) and next to the cartridge. Once
the spacers (121) are in place, snap a 1/8" E-clip (41) into the
groove closest to the cartridge on both front shock shafts (118).
*NOTE: The shock spacers are only used on the front shock shafts.
!
Step 11. Slide a #55 (orange) shock piston (123) onto each of
the two front sock shafts (118) — the shorter of the two lengths —
until the piston (123) rests against the E-clip (41). Secure the pis-
tons (123) to the shafts (118) with a second E-clip (41).
*NOTE: The orange, #55 pistons are used on the front (short)
shock shafts. The red, #56 pistons are used on the rear (long) shock
shafts.
!
Step 12. Slide a #56 (red) shock piston (124) onto each of the
rear shock shafts (119) until it rests against the E-clip (41). Secure
the pistons (124) to the shafts (119) with a second E-clip (41).
BAG E (Continued)
122
41
120
122
118
118
121
123
2 1
Figure 49
41
Figure 50
119
119
124