Table of Contents
Advertisement
Chapter 3: Installation
Connect to Ethernet LAN (with CPU Card)
You can use these instructions for general connection purposes only. The Ethernet hub/switch manufacturer
documentation should provide specific instructions for connection to another device, such as Tenor CMS. One
Ethernet port is enabled; the other three ports are not used.
NOTE:
For illustrations purposes, the unit is shown with CMS240 (2 slot) with AC power.
1
0
Chassis Rear (AC view)
1. Plug one end of the grey RJ-45 ethernet cable into one of the ports on the CPU rear transition module
labeled 10/100 Ethernet.
2. Plug the other end of the cable into the Ethernet hub/switch port. If a custom cable or adapter is required,
see Chapter 2: Hardware Components for Ethernet RJ-45 10/100.
3-8
Figure 3-5 Connect to Ethernet Hub/Switch
Ethernet Hub/Switch
P/N 480-0005-00-15
Data
Network
Advertisement
Table of Contents
