Table of Contents
Advertisement
Chapter 4: Getting Started with Command Line Interface (CLI)
4. Click on Hypertrm.
5. Enter a connection description (i.e., name for each unit such as Tenor CMS 1).
6. Click Ok.
7. Choose a connection port (on your PC) from the Connect Using drop down list box (i.e., Direct to Com 1).
Click Ok. The Com 1 properties window will be displayed.
8. From the Bit Per Second drop down list box, choose 38400.
9. From the Data Bits drop down list box, choose 8.
10. From the Parity drop down list box, choose None.
11. From the Stop bits drop down list box, choose 1.
12. From the Flow Control drop down list box, choose None.
13. Click on Call>Call. A connection to the CMS unit will be established.
14. Enter a login name. The default login name is admin.
15. Enter a password. The default password is admin. (To change this password later, see Chapter 8: Diagnos-
tics/Maintenance. Questions about the unit will scroll on the screen.
NOTE:
Steps 16-18 are used for first time assignment of IP address.
16. For IP address, enter the IP address for the Tenor CMS unit.
17. For Subnet Mask for LAN prompt, enter the subnet mask. This address is used to differentiate the network
portion of the IP address from the host portion of the IP address.
18. For Default Gateway prompt, enter the IP address for the default gateway (router) which routes a packet
data outside of your LAN.
CMS will reboot automatically.
4-10
P/N 480-0005-00-15
Advertisement
Table of Contents
