Table of Contents
Advertisement
Reset System
Reset the system as follows: turn the power switch off and then back on.
Change Password
For security purposes, you may want to change your password. You can change the password via Command
Line Interface (CLI) as follows:
1. Access the CLI through a Telnet session. See Chapter 4: Getting Started with Command Line Interface
(CLI) for more information.
2. Access the Maintain module.
3. Type password. A prompt will ask you for the old password.
4. Type the old password and press Enter. A prompt will ask you for the new password. Type the new pass-
word and press Enter. A confirmation will ask you to confirm the new password.
5. Re-type the new password and press Enter.
A message will tell you the password was changed successfully.
P/N 480-0005-00-15
Chapter 8: Diagnostics/Maintenance
8-12
Advertisement
Table of Contents
