Installation; Download And Install Snmp Related Files - HP 480-0005-00-15 Product Manual

Hewlett-packard carrier multipath switch product guide
Table of Contents

Advertisement

Chapter 5: Working with SNMP

Installation

There are two steps you need to accomplish before HP Openview can interact with a Tenor CMS unit as an
SNMP agent.
Download and install HP Openview configuration files specific for Tenor CMS
Configure the IP address of the network manager in the Tenor CMS

Download and install SNMP Related Files

For HP Openview (network manager) to view and manage the Tenor CMS as an SNMP agent, you must first
download and install files from the www.quintum.com web site as follows:
1. Start up HP Openview. (For specific information, see the user documentation you received with the soft-
ware.) There are two ways to download the applicable files: from the www.quintum.com web site or from
the CD delivered with the system. To download from the web, go to step 2. Otherwise, for CD installation,
go to step 5.
2. From the web site, access a web browser (i.e., Microsoft Internet Explorer, Netscape) and go to the web
site www.quintum.com.
3. Download the installquintum.zip file to your PC.
4. Unzip the installquintum.zip file to the HP Openview root directory (this is the directory in which HP
Openview was installed).
The following files will be listed:
installquintum.bat
quintum.conf
connector_qdvoip
quintum_sym
Tenor_D.ico
5. From the Quintum CD ROM, access the directory <CD ROM Drive>:\software\SNMP and download the
files (the same files listed above) to the HP Openview root directory (this is the directory in which HP
Openview was installed).
6. From the HP Openview root directory run installquintum.bat. Installation will begin. The following sec-
tion lists where the installation files are copied and which files were modified. You can use this informa-
tion to manually make changes to the files, if desired.
NOTE:
If you have already ran the installquintum.bat, you must first run the installlquintum.bat clean com-
mand prior to reinstalling. This command will restore any changes made to the quintum files back
to the default parameters (see below for which files are modified upon installation).
5-4
quintum.reg
quintum.fields
connector_qavoip
Tenor_chassis.ico
quintum.exe
quintum_type
uninstallquintum.bat
Tenor_A.ico
P/N 480-0005-00-15

Advertisement

Table of Contents
loading

Table of Contents