Table of Contents
Advertisement
Chapter 3: Installation
3. Insert the wire into the connector in the position shown in Figure 3-10.
4. Secure by tightening the clamping screw with a straight blade screwdriver of size 0.023x 0.137 (0.6 x
3.5mm). Screws must be torqued between a minimum of 4.4 lbs in (0.5 Nm) and a maximum of 5.3 lbs in
(0.6 Nm).
WARNING:
Do not over torque the screws.
5. Repeat steps 2-4 for the RTN and -48V source, respectively, in the same sequence shown in Figure 3-11.
6. Once the connections are complete between the DC feed(s) and the Tenor CMS power plug (s), insert the
plugs into the power receptacles.
7. Secure the power plugs to each of the power receptacles by torquing the screws in the face of the plug to
between a minimum of 4.4 lbs in. (0.5Nm) and a maximum of 5.3 lbs in. (0.6Nm) with the same screw-
driver. See Figure 3-12. Plug and secure both power plugs, even if only one DC power feed is used.
-48 |RTN|
3-12
Figure 3-9 Strip away wire
DC Power Wire Strip Length
0.25" (7.0mm)
Figure 3-10 Connector position
Figure 3-11 Wire connection sequence
Figure 3-12 Plug and secure power plugs
Secure both screws in the face of the Plug, with a straight
blade screwdriver of size 0.023" x 0.137", (0.6 x 3.5mm)
Caution: Screws must be torqued between a minimum of
4.4 lbs.in,(0.5 Nm) and a maximum of 5.3 lbs. in (0.6 Nm)
10 - 14 AWG
P/N 480-0005-00-15
Advertisement
Table of Contents
