7.
Configure route summarization by specifying the starting address and mask of the range of
addresses to be summarized.
>> OSPF Interface 2 # ../range 1 (Select menu for summary range)
>> OSPF Summary Range 1 # addr 36.128.192.0 (Set base IP address
>> OSPF Summary Range 1 # mask 255.255.192.0(Set mask address
>> OSPF Summary Range 1 # aindex 0 (Inject summary route into backbone)
>> OSPF Summary Range 1 # enable
8.
Use the hide command to prevent a range of addresses from advertising to the backbone.
>> OSPF Interface 2 # ../range 2
>> OSPF Summary Range 2 # addr 36.128.200.0
>> OSPF Summary Range 2 # mask 255.255.255.0
>> OSPF Summary Range 2 # hide enable
9.
Apply and save the configuration changes.
>> OSPF Summary Range 2 # apply
>> OSPF Summary Range 2 # save
Verifying OSPF configuration
Use the following commands to verify the OSPF configuration on your switch:
/info/l3/ospf/general
/info/l3/ospf/nbr
/info/l3/ospf/dbase/dbsum
/info/l3/ospf/routes
/stats/l3/route
See the HP 10Gb Ethernet BL-c Switch Command Reference for information on the above commands.
of summary range)
for summary range)
(Enable summary range)
(Select menu for summary range)
(Set base IP address)
(Set mask address)
(Hide the range of addresses)
(Apply all changes)
(Save all changes)
OSPF
154