Configuring Lacp - HP 445946-001 Application Manual

Configuring LACP

Use the following procedure to configure LACP for port 20 and port 21 to participate in link aggregation.
1.
Set the LACP mode on port 20.
>> # /cfg/l2/lacp/port 20
>> LACP port 20# mode active
2.
Define the admin key on port 20. Only ports with the same admin key can form a LACP trunk group.
>> LACP port 20# adminkey 100
Current LACP port adminkey:
New pending LACP port adminkey: 100
3.
Set the LACP mode on port 21.
>> # /cfg/l2/lacp/port 21
>> LACP port 21# mode active
4.
Define the admin key on port 21.
>> LACP port 21# adminkey 100
Current LACP port adminkey:
New pending LACP port adminkey: 100
5.
Apply and verify the configuration.
>> LACP port 21# apply
>> LACP port 21# cur
6.
Save your new configuration changes.
>> LACP port 21# save
(Select port 20)
(Set port 20 to LACP active mode)
(Set port 20 adminkey to 100)
17
(Select port 21)
(Set port 21 to LACP active mode)
(Set port 21 adminkey to 100)
18
(Make your changes active)
(View current trunking configuration)
(Save for restore after reboot)
Ports and trunking
46