History Mib Objects - HP 445946-001 Application Manual

Requested buckets (/cfg/rmon/hist x/rbnum) are the number of buckets, or data slots, requested by
the user for each History Group. Granted buckets (/info/rmon/hist x/gbnum) are the number of
buckets granted by the system, based on the amount of system memory available. The system grants a
maximum of 50 buckets.
Use an SNMP browser to view History samples.

History MIB objects

The type of data that can be sampled must be of an ifIndex object type, as described in RFC1213 and
RFC1573. The most common data type for the history sample is as follows:
1.3.6.1.2.1.2.2.1.1.x -mgmt.interfaces.ifTable.ifIndex.interface
The last digit (x) represents the interface on which to monitor, which corresponds to the port number
(1-16, 18-21). History sampling is done per port, by utilizing the interface number to specify the port
number.
Configure RMON History (CLI example)
1.
Enable RMON on each port where you wish to collect RMON History.
>> /cfg/port 21/rmon
>> Port 21# ena
>> Port 21 RMON# apply
>> Port 21 RMON# save
2.
Configure the RMON History parameters.
>> /cfg/rmon/hist 1
>> RMON History 1# ifoid 1.3.6.1.2.1.2.2.1.1.21
>> RMON History 1# rbnum 30
>> RMON History 1# intrval 120
>> RMON History 1# owner "Owner_History_1"
3.
Apply and save the configuration.
>> RMON History 1# apply
>> RMON History 1# save
This configuration creates an RMON History group to monitor port 21. It takes a data sample every two
minutes, and places the data into one of the 30 requested buckets. After 30 samples are gathered, the
new samples overwrite the previous samples, beginning with the first bucket. Use SNMP to view the data.
(Select Port 21 RMON)
(Enable RMON)
(Make your changes active)
(Save for restore after reboot)
(Select RMON History 1)
(Make your changes active)
(Save for restore after reboot)
Remote monitoring
159