Power Cord Set Requirements; General Requirements - HP 263924-002 User Manual

The power cord set meets the requirements for use in the country where you
purchased your equipment. The voltage selection switch enables you to select the
appropriate line voltage for your server.
Power cord sets for use in other countries must meet the requirements of the country
where you use the server. For more information on power cord set requirements,
contact your HP authorized dealer.

General Requirements

The following requirements are applicable to all countries:
•
The length of the power cord must be at least 1.8 m (6.0 ft) and a maximum of
3.7 m (12 ft).
•
The power cord set must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord will be used.
•
The power cord set must have a minimum current capacity and nominal voltage
rating of 10 A/125 volts AC or 10 A/250 volts AC, as required by the power
system of each country.
•
The appliance coupler must meet the mechanical configuration of an
EN60320/IEC 320 Standard Sheet C13 Connector for mating with the appliance
outlet on the computer.
HP IP Console Switch User Guide

Power Cord Set Requirements

C
C-1