GE Profile J2S968 SERIES Technical Service Manual page 54

IMPORTANT:
these orifices for future
conversion back to
natural gas.
c. Locate the L.P. orifices. The L.P.
orifices are shipped attached to
the range on the area behind the
storage drawer. Remove storage
drawer to see.
Each orifice will also show a series of
engraved marks (I, II, III or X) located
on the top.
I II III
These marks denote the precise
location of each orifice to the cooktop
burner.
d. Install the L.P. orifices in their precise
locations.
NON-CONVECTION RANGE
II
III
Front of Range
CONVECTION RANGE
Front of Range
Return the natural orifices to the bracket
and reattach the bracket and these
instructions to the range using the screw
previously removed.
ADJUSTING THE
OVEN BURNERS
(On Gas Models only)
CAUTION:
adjustments must be made
before turning on the gas to
the burner. Failure to do so could
result in serious injury due to high
flames and toxic fumes.
Save
X
I
llI
The following
– 54 –
BAKE BURNER
1. Remove the oven door and oven bottom.
2. Remove the four screws securing
bake burner baffle (flame spreader).
Screws
Bake
Burner
Baffle
3. Remove the bake burner baffle (flame
spreader).
4. Remove the orifice fitting cover.
IMPORTANT:
overtighten or you may bend
the orifice hood or needle.
5. Use a 1/2" open-end or adjustable
wrench to turn the orifice hood in
the L.P. direction, clockwise about
1 1 ⁄ turns, until snug.
2
Orifice
Nat.
Fitting
NAT.
Orifice Fitting
Cover
Cover
L.P.
L.P.
Air
Air Shutter
Air Shutter Air Shutter
Shutter
Screw
Screw
Nat. – L.P.
Adjustment Made
NAT. - LP.
to Orifice Hood
ADJUSTMENT
BROIL BURNER
Use a 1/2" open-end or adjustable
wrench to turn the orifice hood in the
L.P. direction, clockwise about 1
until snug.
Air Shutter
Air Shutter
L.P.
L.P.
Shutter
Shutter
Screw
NAT. Nat.
AIR SHUTTER SETTING FOR
BAKE AND BROIL BURNERS
1. Use a screwdriver to loosen the air
shutter screw.
2. Adjust the air shutters. The table
below gives the recommended initial
air shutter setting. Your final settings
may vary.
Screws
Do not
1 ⁄ turns,
2
Air
Air
Screw