GE Profile J2S968 SERIES Technical Service Manual page 44

Cooling Fan
The cooling fan has an approximate resistance
value of 24Ω.
The oven uses a fan for cooling the oven
components. Air is pulled in by the fan blades and
circulated in the component compartment. The air
is exhausted through louvers below the control
panels and out the slots above the door.
Cooling Timing Parameters JGS968
The cooling fan comes on when the oven is on. If
the temperature is set over 300°F and the oven is
turned off, the fan will remain on until the
temperature drops below 300°F or 85 minutes
has elapsed.
Cooling Timing Parameters J2S968
The cooling fan comes on when the oven is on. If
the temperature is set over 175°F and the oven is
turned off, the fan will remain on until the
temperature drops below 175°F or 85 minutes
has elapsed.
Cooling Timing Parameters JGSP48
The cooling fan comes on when the oven is on. If
the temperature is over 300°F and the oven is
turned off, the fan will remain on until the
temperature drops below 300°F.
The cooling fan is located under the heat shield of
the maintop burner assembly.
To remove the cooling fan:
1. Remove the maintop burner assembly (see
Maintop Burner Assembly).
2. Remove the upper heat shield (see Upper and
Lower Heat Shield).
3. Disconnect the wiring from the cooling fan
motor.
4. Use pliers to remove the plastic insulation
fasteners from the sides of the fan housing.
5. Remove the 4 mounting screws that hold the
cooling fan in place. Remove the cooling fan.
– 44 –
Disconnect